Emergency Exit Hardware

• Single point locking

• Diecast control boxes

• Follower on main box for use with AR885 locking attachment

• Oval steel rods

• Reversibile

• Oval steel rods

• Suitable for door widths up to 1200mm

• AR882 has been successfully tested to all the requirements of BS EN1125: 1997 clause 6 (severe duty 200,000 cycles)

• Available finishes: Silver, Gold, Black, Polished Brass, Satin & Polished Stainless Steel

• Maintains all of the feature benefits of the AR880 Single Panic Bolt with the exception of the cross Bar Operator which is replaced with a Push Pad

• Recommended as a replacement for AR883 when additional security is required

• AR884 has been successfully tested to all the requirements of BS EN1125: 1997 clause 6 (severe duty 200,000 cycles) Test reports and/or certificates are available on request. AR884 should not be used in OPEN PUBLIC AREAS

• Available finishes: Silver, Gold, Black, Polished Brass, Satin & Polished Stainless Steel

• Single point locking

• Diecast control boxes

• Follower on main box for use with AR885 locking attachment

• Reversible

• Suitable for any door width

• Self handling

• AR883 has been successfully tested to all the requirements of BS EN1125: 1997 clause 6 (severe duty 200,000 cycles) Test reports and/or certificates are available on request. AR884 should not be used in OPEN PUBLIC AREAS

• Available finished: Silver, Gold, Black, Polished Brass, Satin & Polished Stainless Steel

Standard Features:

• Diecast control boxes

• Suitable for all items within range

• Available without cylinder (order AR886)

• Unique pad handle design

Applications:

• For use with all Pinnacle Emergency Exit Hardware

Finishes:

• Silver, Gold and Black

Standard Features:

• Diecast control boxes

• Suitable for all items within range

• Available without cylinder (order AR886K)

• Unique Hexagonal Knob design

Applications:

• For use with all Pinnacle Emergency Exit Hardware

Finishes:

• Silver, Gold and Black

Standard Features:

• Based on CodeLock 500

• Supplied with spindles and patented springs

Applications:

• For use with all Pinnacle Emergency Exit Hardware

Finishes:

• Satin Stainless Steel

The UK Construction Products Regulations require PANIC AND Emergency exit devices FOR USE ON escape doors TO BE SAFE AND DURABLE. BRITSH/EUROPEAN STANDARDS BS EN1125/179 are now the recognised way of demonstrating compliance and they require that an official Notified Certification Body proves both the product and the manufacturers control, before CE making can be applied.

WITH EFFECT FROM APRIL 1st 2003 EUROPEAN LAW WILL REQUIRE ALL RELEVANT PRODUCTS TO BE CE MARKED.

BS EN1125 1997 - Panic Exit Devices

Experience relating to escape from buildings and general safety have made it desirable that doors at exits in public buildings and places as well as dhops etc should be fitted with panic devices operated by a horizontal bar. The emphasis for products covered by this standard is ON SAFE EXIT RATHER THAN SECURITY.

BSEN179 1998 - Emergency Exit Devices

This standard covers devices to be used in emergency situations where people are familiar with the emergency exit and its hardware and therefore a panic situation is most unlikely to develop. Lever handle operated escape mortice locks or push pads may therefore be used. THESE DEVICES MUST NOT BE USED IN OPEN PUBLIC AREAS.

Double Panic Bolts for Double Rebated Doors

The traditional Double panic bolt is NO LONGER PERMISSIBLE under the requirements of the new standard. Specifications MUST PROVIDE a single panic bolt and panic latch for pairs of doors with REBATED meeting sites. When panic latches are used in this situation they must be fitted to the first opening leaf of the door set. Pairs of doors with plain meeting stiles should be fitted with two single panic bolts.